Industry News

Log splitters use a hydraulic system to perform the splitting work. Using a hydraulic filter log splitter can help you split a large number of logs in a relatively short time; the machines are particularly useful in colder climates where heat is supplied by wood fireplaces or stoves. A log splitter's hydraulic filter system uses hydraulic fluid, sometimes called hydraulic oil, that's supplied from a reservoir. The fluid line must be filtered to prevent wood chips and other particles from entering the hydraulic system.And if you want to know the information about the hydraulic filter, please consult WUZHOU KINGDA.

Instructions

1

Take the suction hose off the bottom of the hydraulic reservoir. The hydraulic reservoir is found at the end of the line that runs from the hydraulic arm on the splitter.

2

Unthread the inlet hydraulic filter and discard it if the splitter has been used for 50 hours since the hydraulic filter was last replaced. Clean it with penetrating oil if the filter is younger than 50 hours.

3

Install the new or cleaned hydraulic filter by re-threading the filter onto the hose and reservoir inlet.